Publicité
Les langues disponibles
Les langues disponibles
EnGlIsH
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that Philips offers,
register your product at www.philips.com/welcome.
With your new Satinelle ICE you can remove unwanted
hairs quickly, easily and effectively. The combination of
the ceramic epilating system, the cooling glove and the
massaging system constitutes a revolution in epilation.
Thanks to the natural numbing effect of ice and massaging,
the Satinelle ICE makes epilation more comfortable and
less painful than ever. The result is a silky-smooth skin and
a hair growth reduction of up to 50%, assuming you use
the appliance regularly (every 4 weeks).
The rapidly rotating epilating discs catch even the
shortest hairs (down to 0.5 millimetre) and pull them out
by the roots. As a result, your skin stays smooth for up to
four weeks and regrowth is soft and downy.
General description (Fig. 1)
A
Massaging element
B
Epilating head
C
Release button
D
On/off slide
E
Socket for small plug
F
Cleaning brush
G
Adapter
H
Cooling glove
I
Ice gel pad
J
Peeling glove
K
Luxury storage bag
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
-
Keep the appliance and the adapter dry.
-
Do not use the appliance near or over a washbasin
or bath filled with water.
-
Do not use the appliance in the bath or in the
shower.
-
If you use the appliance in the bathroom, do not use
an extension cord.
Warning
-
Check if the mains voltage indicated on the appliance
corresponds to the local mains voltage before you
connect the appliance.
-
Only use the appliance in combination with the
adapter supplied.
-
Do not use the appliance if the adapter or the
appliance itself is damaged.
-
If the adapter is damaged, always have it replaced
with one of the original type in order to avoid a
hazard.
-
The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
-
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
-
Children should be supervised to ensure that they
do not play with the appliance.
Caution
-
Do not expose the appliance to temperatures lower
than 5°C or higher than 35°C.
-
To prevent damage and injuries, keep the running
appliance away from scalp hair, eyebrows, eyelashes,
clothes, threads, cords, brushes etc.
-
Do not use the appliance on irritated skin or skin
with varicose veins, rashes, spots, moles (with hairs)
or wounds without consulting your doctor first.
People with a reduced immune response or people
who suffer from diabetes mellitus, haemophilia or
immunodeficiency should also consult their doctor
first.
-
Your skin may become a little red and irritated the
first few times you use the epilator. This phenomenon
is absolutely normal and quickly disappears. As
you use the appliance more often, your skin gets
used to epilation, skin irritation decreases and
regrowth becomes thinner and softer. If the irritation
4203.000.4199.1
has not disappeared within three days, we advise you
to consult a doctor.
-
Do not use the exfoliating body puff immediately
before or after epilation.
General
-
Regular massages with the exfoliating body puff may
help to prevent ingrowing hairs.
-
Regular cleaning and proper maintenance ensure
optimal results and a long life for your appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user
manual, the appliance is safe to use based on scientific
evidence available today.
Preparing for use
Freezing the ice gel pad
-
Read these instructions carefully before you use the
cooling glove (Fig. 2).
Keep the ice gel pad out of the reach of children (Fig. 3).
Do not use a damaged ice gel pad (Fig. 4).
Do not use the ice gel pad if you are hypersensitive to
cold.
1
Put the ice gel pad without the cooling glove in the
freezer or freezing compartment (***) at least 2
hours before you start to epilate. (Fig. 5)
Make sure the outside of the ice gel pad is completely
dry before you freeze it.
Tip: You can store the ice gel pad in the freezer permanently.
Using the appliance
General information about epilation
-
Epilation is easier just after a bath or shower. Make
sure your skin is completely dry when you start to
epilate.
-
When you use the appliance for the first time, we
advise you to try it out on an area with only light
hair growth. This helps you get accustomed to the
epilation process.
-
For optimal epilation results, the hairs should not
be longer than 10mm. Use one of the following
methods if the hairs are longer than 10mm:
1
Shorten the hairs to a maximum length of 10mm
with a trimmer. Afterwards you can immediately start
with epilation.
2
Shave the hairs completely. Then you can start to
epilate after a few days (minimum hair length 0.5mm
necessary).
-
Your skin may become a little red and irritated the
first few times you use the epilator. This phenomenon
is absolutely normal and quickly disappears. As you
use the appliance more often, your skin gets used
to epilation, skin irritation decreases and regrowth
becomes thinner and softer. If the irritation has not
disappeared within three days, we advise you to
consult a doctor.
-
We advise you to epilate before you go to bed
at night, as this allows any skin irritation that may
develop to diminish overnight.
Epilating with the cooling glove
Make sure your skin is clean, entirely dry and free from
grease. Do not use any cream before you start to epilate.
1
Insert the appliance plug into the bottom of the
appliance and put the adapter in the wall socket.
2
Put the ice gel pad in the compartment of the
cooling glove with the transparent cover (Fig. 6).
Only use the ice gel pad in combination with the cooling
glove.
3
Push your hand into the cooling glove and start
cooling the area you want to epilate (Fig. 7).
Do not leave the cooling glove on the same area for
more than 2 minutes.
4
Select the desired speed to switch on the
appliance (Fig. 8).
-
Select speed 1 for areas with little hair growth and
for areas where bones are located directly beneath
the skin, such as knees and ankles.
-
Select speed 2 for larger areas with stronger hair
growth.
5
Stretch your skin with your free hand to make the
hairs stand upright.
6
For optimal results, place the appliance
perpendicularly onto the skin with the on/off
slide pointing forward. Move the appliance against
the direction of hair growth at a moderate
speed (Fig. 9).
Make sure both the epilating discs and the massaging
element are in proper contact with the skin.
Make sure your skin is completely dry when you start
to epilate.
7
Press the appliance lightly onto the skin.
If you are not completely satisfied with the epilation
result, try moving the epilator more slowly over your skin.
Epilating without cooling glove
If you do not want to use the cooling glove, for instance
because you have grown accustomed to the sensation
of epilation, you can also use the appliance without the
cooling glove.
1
For optimal results, place the appliance
perpendicularly onto the skin with the on/off
slide pointing forward. Then move the appliance
against the direction of hair growth at a moderate
speed (Fig. 9).
Using the peeling glove
Use the peeling glove in the shower.
Regular massages with the peeling glove may help to
prevent ingrown hairs. Do not use the peeling glove
immediately before or after epilation.
Cleaning and maintenance
Never rinse the adapter or the appliance itself with
water.
Do not use any corrosive detergents, scouring pads or
cloths, petrol, acetone etc. to clean the appliance.
Cleaning the cooling glove
1
Make sure the appliance is switched off and
unplugged.
2
Remove the ice gel pad from the cooling glove.
3
Clean the cooling glove with a moist cloth after
each use.
Make sure the outside of the ice gel pad is completely
dry before you freeze it again.
Cleaning the epilating head
1
Make sure the appliance is switched off and
unplugged.
2
Remove the epilating head (Fig. 10).
Press the release button (1) and pull the epilating head
off the appliance (2).
3
Clean the epilating head, including the epilating
discs and the plastic housing, with the cleaning
brush (Fig. 11).
4
For thorough cleaning, you can remove the
massaging element (Fig. 12).
5
You can also rinse the epilating head (not the
appliance!) under the tap to clean it more
thoroughly (Fig. 13).
Never try to detach the epilating discs from the epilating
head.
6
Place the epilating head on the appliance and
press it onto the appliance until it snaps home
('click') (Fig. 14).
The epilating head only fits onto the appliance in one way.
storage
1
Store the appliance and the accessories in the
pouch.
Environment
-
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 15).
-
If the ice gel pad is damaged, you can throw it away
with the normal household waste.
2/6
Publicité
