ASROCK ALiveDual-eSATA2 Guide D'installation Rapide page 15

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 24)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.2, No. 17)
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors (Black)
(SATA1: see p.2, No. 13)
(SATA2: see p.2, No. 11)
Serial ATAII Connectors
(SATA II_1, red: see p.2 No. 9)
(SATA II_2, orange: see p.2 No. 10)
ASRock
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2, No. 18)
80-conductor ATA 66/100/133 cable
These two Serial ATA (SATA)
connectors are supported by
NVIDIA
SATA2
southbridge, support SATA data
SATA1
cables for internal storage
devices. The current SATA
interface allows up to 1.5 Gb/s
data transfer rate.
These two Serial ATAII (SATAII)
connectors are supported by
JMicron
interface), support SATA
data cables for internal storage
SAT AII_2 SA T AII_1
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
ALiveDual-eSATA2 Motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
®
nForce3 250
® JMB363 (PCIE x1
1 5 1 5 1 5
1 5 1 5