Intended Use; Parts List For Dp Dispenser - Sulzer DP 200-70 Manuel D'instructions D'utilisation

Dispenser DP
The following instructions must be read and strictly observed:
•
The user of the dispenser and any persons
standing in the vicinity must wear safety
goggles and gloves at all times during
operation of the dispenser.
•
The user should never point the barrel end of the dispenser at
himself or in the direction of bystanders [animals] or objects during
operation.
•
Never open the pneumatic drive or attempt to remove.
•
Handle the dispenser properly. Store in a cool dry place. Transport
it carefully, with minimal vibration. Do not drop it to the ground or
slam it on a bench or other workspace.
•
Safety devices must not be removed, worked around, bypassed or
deactivated during operation.
•
Always comply with the warnings and notices on the device. Never,
under any circumstances, remove these warnings and notices.
Replace them immediately if they become detached or illegible.
•
Do not remove, tamper or manipulate pressure limiting valve and
strictly respect pressure limits.
•
Check the dispenser for visible damage and defects before each
use. The dispenser must only be used if it is in good working order.
If you have any doubt about the condition of the dispenser, or if
there are any signs of breakage or other damage, immediately stop
using the device and send it for inspection and repair by a site
authorized by the manufacturer.
•
Keep the dispenser clean at any time. Failure to do so may result in
malfunction of dispenser or bodily injury.
•
Do not attempt to modify or repair the dispenser. Maintenance and
repairs must be carried out exclusively by qualified specialists. No
such work may be carried out while the dispenser is connected to
the compressed air supply.
•
Always follow safe workplace practices, such as making sure the air
hoses are carefully routed so that neither you nor any other person
can become entangled in the hoses or trip over them.
•
Be cautious connecting and disconnecting air pressure hose.
•
Always keep this instruction manual easily accessible to users of the
dispenser.
•
Only authentic Sulzer Mixpac spare parts may be used. Malfunctions
or accidents may result if spare parts of other manufacturers are
2009-03 (V 2.0)
22905825v3
Sulzer Mixpac AG
4
Dispenser DP
used, and any warranty claims against the manufacturer will be
considered void.
•
Replace missing or damaged hazard warning labels / stickers.
Modifications or changes to the dispenser by persons not
authorized by the manufacturer and any failure to comply
with the safety instructions given in the Operating Instruction
Manual are dangerous and can lead to accidents with severe
injuries and / or property damage.
Intended use of the dispenser
The dispenser has been developed for mixing and applying
2-component adhesives of various different formulas. Any other or
additional applications shall be considered as nonconforming, i.e. not
conforming to the intended use.
compliance with the instructions in this Operating Instruction Manual as
a basic requirement.

2. Parts list for DP dispenser:

1. Cartridge guide
2. Type designation and serial number
3. Plunger
4. Dispense volume indicator
5. Pneumatic drive unit
6. Piston rods
7. Cartridge ejector button
8. Cartridge sleeve
9. Trigger
10. Pressure limiting valve
11. Compressed air supply
12. Handle
13. Red button (retract piston rod)
2009-03 (V 2.0)
22905825v3
Sulzer Mixpac AG
The intended use also includes
5