Iluminarc COLORIST POD 7Qa Guide De Référence Rapide page 5

Colorist™ Pod 7Qa QRG
DMX Linking
DMX Connection
IP65 DMX Cable
Table
IP65 DMX
Connector Pins
Control Panel
Description
Passcode
The Colorist™ Pod 7Qa will work with a DMX controller using a regular
DMX serial connection.
www.iluminarc.com.
The Colorist™ Pod 7Qa uses a regular DMX data connection for its
DMX personalities: 4-CH, 6-CH, and 10CH. See the User Manual to
connect and configure for DMX operation.
Connection
Ground
Data -
Data +
Male IP65 (DMX Input)
To connnect the Colorist™ Pod 7Qa to your DMX network, it is
necessary to use the 3-pin to 5-pin adapters supplied with this
product.
When not using the Power Output, DMX Input or DMX Output
connectors, you must seal the cable ends with the supplied caps.
Button
<MODE> Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list or increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list or decreases
<DOWN>
the numeric value when in a function
After being prompted, enter the following passcode by pressing:
·
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This passcode cannot be changed and must be used whenever prompted.
A DMX
DMX (U.S.) DMX (Europe)
Shield
White
Red
F
Function
5
Primer is available
IP65 Pin
Shield
Blue
Brown
emale IP65 (DMX Output)
EN
from
1
2
3