Imetec N0304 Instructions Pour L'emploi page 12

damp feet or barefoot.
• DO NOT pull the supply cord or the appliance
itself to remove the plug from the socket.
• DO NOT pull or lift the appliance by the supply
EN
cord.
• DO NOT expose the appliance to humidity or
atmosferic agents (rain, sun, etc.) or extreme
temperatures.
• The appliance must not be left unattended while
it is connected to the mains supply.
• Always disconnect the appliance from the
mains supply before cleaning or performing
maintenance and when the appliance is not in
use.
• If the appliance is faulty or malfunctions,
switch it off and do not tamper with it. Contact
an authorised technical service centre for any
repairs.
• If the supply cord is damaged it must be replaced
by an authorised technical service centre, so as
to prevent all risks.
• When the appliance is used in a bathroom,
unplug it after use since the proximity of water
presents a hazard even when the appliance is
switched off.
• for additional protection, the installation of a
residual current device (RCD) having a rated
residual operating current not exceeding
30 mA (ideal 10 mA) is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
• This appliance shall not come into contact with
water, other liquids, spray, steam. for any
cleaning and maintenance operation referto the
instructions in the relevant chapter.
WARNING! DO NOT use this appliance
near bathtubs, showers, basins or other
vessels containing water.
10