F-One TRUST 2014 Manuel page 19

RELAUNCH
STOP & GO
Stop & Go : the kite sits at the edge of the
flying window, waiting for you to relaunch it.
It can stay in this position until you decide to
1
relaunch it.
Tips to Relaunch
SWINGING THE KITE ON ITS TIP
2
3
4
www.f-onekites.com
To relaunch, grab the bar and pull on the
side connected to the top wing tip (the one
out of the water)
Swing the kite in difficult situations:
In light wind conditions, you can help the kite
to swing on its tip by pulling directly on the
front lines above the bar. You can walk to-
wards the kite If you are within your depth.
Think about this technique for a faster re-
launch (in waves or when facing an obsta-
cle)
36
Repairing the leading edge
In case of small leak :
If you have a leak on the leading edge, remove it with its connection pipe
Thus you can close all the air exits with the clips to find the leaks.
Proceed as follows :
1. Disconnect the leading edge on the blader's side
2. Tie one line on each side of the leading edge and take off the leading edge
3. Find the leak
4. Sand then stick the repair patch (enclosed in the repair kit)
5. Reconnect the leading edge. To replace the clip, it is necessary to stretch the pipe
1
5
2
6
7
4
8
37
REPAIRING
1
3
4
www.f-onekites.com