Télécharger Imprimer la page

Oster PRO 3000i Manuel D'instructions page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
5. Hold the charger firmly with one hand
and pull the clipper or the battery out
with the other.
NOTE: Except when charging, always
unplug this appliance from the electrical
outlet immediately after using.
About the LiION Battery
NOTE: To ensure that the new battery
reaches its full potential, the battery
should be completely drained after the first
use. This operation will only have to be
performed once.
It will take no more than 120 minutes for
the battery to be fully charged when fully
discharged.
Additionally, to ensure the longevity of
this powerful battery, the clipper must be
operated with properly cleaned, sharpened
and oiled blades at all times. When the
battery is fully charged, the clipper can be
used for up to 2 hours without recharging.
This capacity is typically attained after
approx. 1 - 5 charging cycles.
For instructions on disposal of the LiION
battery please refer to the "DISPOSAL"
section at end of this manual.
Changing the Batteries
1. Move the switch to the off position
2. Push the battery interlock on both
sides inward and pull the battery out of
the clipper.
3. Fit the charged battery in the clipper,
till the battery interlock is engaged on
both sides (Figures 4 and 5).
Figure 4
Figure 5
- English-5 -
Cordless Operation
Remove the clipper from the charging
stand. (See section titled "CHARGING
THE UNIT" before initial use.) The
charging stand LED should stay
green or switch to red when the spare
battery is not fully loaded.
Turn the clipper on using the "On-Off"
switch located on the top of the unit
and use the clipper.
Turn the clipper off after use.
Cover the blades with the provided
blade guard to protect the blades.
Insert clipper into charging stand. (See
section titled "CHARGING THE UNIT".)
Blade Replacement
To Remove:
IMPORTANT! STOP MOTOR; lift blade
away from clipper, and slide off tongue.
Some models may require you to push
in locking mechanism located below
the heel of the blade before removing.
To Replace:
Turn motor on; insert blade on tongue
and fully insert blade then snap blade
into place.

Publicité

loading

Ce manuel est également adapté pour:

078003