Publicité
Les langues disponibles
Les langues disponibles
Charging The Clipper
•
Plug the power cord of the charging
stand into an outlet with the rated
voltage for your unit.
•
Ensure that the switch on the unit is in
the "Off" position.
•
Test the contacts of the clipper and
the battery for foreign particles and
contamination.
•
Insert clipper with the battery inserted
into the charging stand so that the top
of unit is facing you and the contacts
on the clipper are aligned with the
contacts on the charging stand. The
top of the unit is the side with the
switch (Figure 1).
•
While the unit is being charged the
LED will display a red solid light until
fully charged. Once the battery is
fully charged, the LED will display a
continuous green light and is ready
for use. This charging stand has one
control LED.
Led Indicator
Charging
Fully Charged
Charging Stand Ready green solid
ABOUT THIS CLIPPER
Figure 1
red solid
green solid
•
If the LED will not turn on, then remove
and re-insert the clipper into the
charging stand and push down gently
on the clipper to engage the contacts.
NOTE: If the LED does not turn on
then there may be dirt or grease on
the contacts of the charging stand
or clipper. Clean the contacts with
an approved cleaning solution and
re-insert the clipper into the charging
stand. If the LED still fails to turn on
then follow the return procedure under
the warranty and service section.
•
The LED will stay on as long as the unit
is in the charging stand and plugged in.
Charging a Battery Using
the Charging Stand
1. Test the contacts of the battery for
foreign particles and contamination.
2. Insert the battery into the charging
stand so that the contacts of the
battery are aligned with the contact of
the charging stand (Figures 2 and 3).
Figure 2
3. Keep the battery in the charging station
for the recommended charging time: 45
minutes.
4. The battery is charging when the
control light is illuminating red. As soon
as the battery is fully charged, the
green control light will light up and the
charger will switch to trickle charge.
- English-4 -
Figure 3
Publicité
