Preparing The Intelligent Pantilter; Inserting Batteries - Sony Parte-shot IPT-DS1 Mode D'emploi

Station intelligente (inclinaison horizontale et verticale)
Masquer les pouces Voir aussi pour Parte-shot IPT-DS1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Preparing the
intelligent pantilter

Inserting batteries

You can use the following batteries.
Two AA alkaline batteries
ˎ
Two AA Nickel-Metal Hydride batteries
ˎ
¦
Notes
Be careful not to touch the multi connector when
ˎ
holding this unit.
You cannot use manganese batteries.
ˎ
¼
Tips
If you do not intend to use this unit for a long time,
remove the battery.
1 Slide the ON/OFF (power) switch of this
unit to OFF and then open the battery
cover.
2 Insert the batteries into the battery
compartment according to the marks
inside the compartment.
3 Close the battery cover.
To remove batteries
Slide the ON/OFF (power) switch of this unit to OFF
and then remove the batteries.
¦
Notes
Be careful not to let the batteries fall when
ˎ
removing them.
Always use the same kind of batteries together.
ˎ
Check the polarities of the batteries when inserting
ˎ
them into this unit. If you insert the batteries in the
wrong direction, this unit does not work.
Do not use a charged AA Nickel-Metal Hydride
ˎ
battery with a dead AA Nickel-Metal Hydride
battery.
Battery level
If the battery level is low, indicator B flashes slowly. If
the battery level gets lower, indicator B flashes more
rapidly and this unit automatically enters standby
mode.
Using an external power source
By using the AC adaptor AC-LS5K/AC-LS5 (sold
separately), you can supply power to your camera via
this unit and enjoy longer automatic shooting.
Connecting method
Connect the AC adaptor to DC IN with the mark
 on the AC adapter facing down.
Read the user's manual of the AC adaptor.
¦
Notes
Batteries in this unit or your camera are not
ˎ
charged with the AC adaptor.
You cannot select [No Limit] for the rotation angle.
ˎ
Route the cable so that it does not hinder the
ˎ
rotation of this unit.
If you turn your camera off before turning this
ˎ
unit off, the shooting frequency, rotation angle and
other settings you have changed on your camera
may not be stored.
When power is supplied by the AC adaptor, always
ˎ
finish automatic shooting before turning off your
camera.
Removing your camera from this unit
ˋ
Turning this unit off
ˋ
Disconnecting the AC adaptor
ˋ
9-GB

Publicité

Table des Matières
loading

Table des Matières