Troubleshooting; Trademarks - Sony Parte-shot IPT-DS1 Mode D'emploi

Troubleshooting

If any problems occur with your products, refer to the following solutions.
If the problem persists, contact your Sony dealer.
Symptom
Indicator A flashes rapidly in
white.
Indicator B slowly flashes in red.
Indicator B continues to flash
rapidly in red.
This unit does not turn on.
Your camera does not turn on.
Your camera cannot be attached
properly to this unit or is
unstable.
No images are shot.
This unit stops moving during
use.

Trademarks

"Party-shot" are trademarks of Sony Corporation.
ˎ
In addition, system and product names used in this manual are, in general, trademarks or registered
ˎ
trademarks of their respective developers or manufacturers. However, the
cases in this manual.
14-GB
Your camera has exceeded the number of recordable images.
ˎ
Remove your camera from this unit and delete some images.
‚
The lens cover of your camera is closed.
ˎ
Open the lens cover.
‚
The batteries are low.
ˎ
Prepare new batteries.
‚
The plate is not mounted properly.
ˎ
Mount the plate for your camera properly.
‚
Your camera is not attached to this unit.
ˎ
Attach your camera to this unit.
‚
The cable is caught in this unit.
ˎ
Something is caught in this unit.
ˎ
Your hand is pressing against this unit.
ˎ
Resolve the problem and turn this unit back on.
‚
The batteries are low.
ˎ
Replace the batteries (page 9).
‚
The AC adaptor is loose.
ˎ
Connect the AC adaptor (sold separately) properly.
‚
Your camera is not properly attached to this unit.
ˎ
Attach your camera properly to this unit (page 10).
‚
The AC adaptor is disconnected.
ˎ
Connect the AC adapter
‚
The battery level is low.
ˎ
Install charged batteries.
‚
The base or plate is not mounted properly.
ˎ
Attach your camera properly.
‚
Your camera is set too far from or too close to the subject.
ˎ
Set your camera within the face detection range of your camera.
‚
If there is only a small change in facial expression or composition,
‚
a shot may not be taken right away even when a face is detected.
Your camera is in [Set to on for demo mode].
ˎ
Change the setting of your camera. For details, refer to the user's
‚
manual of your camera.
If this unit does not detect any faces, it may automatically stop
ˎ
looking for faces to save power if the shooting frequency is set to
other than [Shoot at high frequency] (page 12).
Cause/Solution
(sold separately) properly.
®
™
or marks are not used in all