Publicité
Les langues disponibles
Les langues disponibles
ON/OFF SWITCH (FIG 1)
The work light is equipped with an ON/OFF switch (7). Press the switch once to turn the work light on and press the
switch a second time to turn it off.
NOTE:
The work light is always on its brightest setting when switched on.
CHANGING THE LIGHT MODE (FIG 1)
The work light has a separate mode selection button switch (8). Press the switch to change the light mode: High
(100%), Medium (50%), Low (25%) and Flashing.
ADJUSTING THE LIGHT DIRECTION
Your work light can be tilted vertically up to 30° down or 90° up.
To Adjust the Light Direction
retighten knobs.
WARNING:
may impair the function and/or safety and could affect the life of the product. There are specific
applications for which the work light was designed.
There are no user-replacable parts. Periodically inspect the condition of adaptors, connectors and wires. Contact the
manufacturer to replace any components that have become worn or broken.
12V DC ADAPTOR FUSE REPLACEMENT (FIG 4)
The fuse in the plug end of the 12V DC adaptor protects the adaptor's charging circuit. If the 120V AC adaptor works,
but the 12V DC adaptor does not, then the fuse may be burned out (blown).
To Replace the Fuse
1. Unscrew the red end cap (6A) off the DC plug.
2. Remove the center contact and fuse (6B).
3. Check to see if the fuse is burned out. The fuse is burned out
when the fuse element is missing or broken inside the glass.
4. Replace with a new 4A fuse if fuse element is missing or
broken. NOTE: Use a 4A fuse only.
5. Screw the end cap and center contact back on until finger
tight--Do not over-tighten.
English
,
loosen the side locking knobs (5). Adjust the work light head to desired position, and
MAINTENANCE
Do not modify the work light in any way. Unauthorized modification
5
6
FIG 4
6A
6B
Publicité
