Dell Precision M60 Serie Guide D'information page 26

Connect the computer to an electrical outlet.
3
NOTE: If you cannot see anything on your display, you can hold down the mute button and press
the power button (instead of F12) to begin the Dell Diagnostics. You do not need to highlight
Diagnostics and press
Assessment.
Turn on the computer. When the DELL™ logo appears, press
4
If you wait too long and the Microsoft
until you see the Windows desktop. Then shut down your computer and try again.
When the boot device list appears, highlight Diagnostics and press
5
The computer begins to run the Pre-boot System Assessment, a series of embedded
diagnostics that perform initial testing on your system board, keyboard, hard drive, and
display.
•
•
•
•
If the Pre-boot System Assessment completes successfully, you receive the message
Booting Dell Diagnostic Utility Partition. Press any key to
continue
Press any key to start the Dell Diagnostics from the Diagnostics utility partition on
6
your hard drive.
24
System Infor mation Guide
During the assessment, answer any questions that appear.
If a component failure is detected, the computer stops and beeps. To stop the
assessment and reboot to the operating system, press
next test, press ; to retest the component that failed, press
If failures are detected during the Pre-boot System Assessment, write down the
error code(s) and contact Dell (see "Getting Help" in your User's Guide for the
appropriate contact information) before continuing on to the Dell Diagnostics.
If you receive a message stating that no Diagnostics utility partition has been
found, follow the instructions on the screen to run the Dell Diagnostics from your
Drivers and Utilities CD.
.
. The computer automatically runs the Pre-boot System
® ®
Windows logo appears, continue to wait
immediately.
.
; to continue to the
.