hawa Variotec 150 H Mode D'emploi page 7

H A W A
150 H
Use of the product
Intended use
This hardware is intended for use in protected interior rooms. Install and use in dry rooms only.
Hardware overview
Articles are identified by a five-digit number.
Personnel qualification
Installation work must be carried out by authorised persons only. Authorisation is granted to persons who:
have received training in technical installation or have acquired appropriate experience.
•
Assembly notes
The installer is responsible for fastening the hardware at the intended location, such as wall, ceiling, floor, etc. The
installer must define the quantity, dimensioning and load-bearing capacity of the fastening screws to an extent that
ensures the intended load-bearing capacity of the hardware including adequate risk excess is provided.
Furthermore, it must be ensured prior to installing the hardware that the hardware and the sliding door attached to it
do not exceed the maximum permissible load applicable to the point of installation.
Climatic conditions must be taken into consideration to prevent the corrosion of fastening components.
Use adequate means to prevent any unintentional loosening of fastening screws.
Maintenance and cleaning instructions
No maintenance work is required.
Risk and residual risk
The hardware does not pose any risk or residual risk.
Variotec 150/H – parallel
parallel | parallel | parallèle
7 7