Baby Trend XCEL-R8 Jogger Manuel D'instruction page 3

WARNING
• Recommend that the child occupant be at least 6 months of age prior to
use of the stroller for jogging. Because children develop at different rates,
please discuss the use of a jogging stroller with your health care provider
prior to jogging with your child.
• NEVER allow your stroller to be used as a toy.
• To clean use only mild household soap or detergent and warm water on a
sponge or clean cloth.
• Check your stroller for loose screws, worn parts, torn material or stitching
on a regular basis. Replace or repair parts as needed.
• Discontinue use of stroller should it malfunction or become damaged.
Please contact our customer service Parts Hotline to arrange for repair or
obtain replacement parts.
IMPORTANT!
stroller, please follow these instructions carefully. Please
keep these instructions for future reference.
IMPORTANT!
inspect this product for damaged hardware, loose joints,
missing parts or sharp edges. NEVER use if any parts are
missing or broken.
IMPORTANT!
Remove stroller from box. The front wheel and rear
wheels MUST be installed prior to use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the following section:
1) • Unlock the release lever (Fig. 1a). Unfold
stroller frame by pulling backward on the
stroller handle.
3
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
To ensure safe operation of your
Before assembly and each use,
Adult assembly is required.
Lean the stroller backwards so that
it rests on the handle and rear axle
frame and the front wheel forks are
pointing upward (Fig. 1b).
2) • Slide the front wheel onto the front
forks (Fig. 2).
3) • Slide the retainer plates onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with
the slot before tightening the wheel
(Fig. 3).
4) • With the wheel in position, tighten the
axle nuts with standard crescent, box,
or open-end wrench. You should feel
significant resistance and the wheel
should be held tightly in place (Fig. 4).
Fig. 1a
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 1b
Fig. 2
Slot Front Fork
Axel Nut Retainer Plate Axel and Hub
Fig. 3
Fig. 4
4