What to do if...
PROBLEMS
None of the lights are lit.
The machine does not heat
up.
The iron does not heat up.
No steam is produced.
Water is produced with the
steam.
The machine makes a
noise.
ANTI-CALC pilot light
flashes or is lit
The on / off pilot light
flashes
28
Causes
- Power supply problem
- Appliance not plugged in or On/
Off button not pressed
- Automatic safety system is triggered
if steam station has not been used
for 10 minutes
- Other
- Linéa 2.0 : Thermostat dial at the
off position
- Other
- When you call for steam right at
the start,
- Appliance not ready
- The reservoir is empty
- The reservoir is incorrectly inserted
or has not been inserted
- The anti-scale cartridge has not
been inserted
- The pilot light ANTI-CALC flashes
or is on
- Other
- Linéa 2.0: The iron soleplate is not
hot enough
- Over steaming
- Water condensation in the hose
- Other
- There is no water in the reservoir
- The reservoir is incorrectly inserted
or has not been inserted.
- Other
- Anti-scale cartridge needs to be
replaced
- The appliance is not ready.
SOLUTIONS
- Check the plugs and mains.
- Plug in the appliance and press the
On/Off button.
- Press the On/Off switch to restart the
appliance.
- Go to your local dealer.
- Put the dial to the desired
temperature.
- Go to your local dealer.
- Press the steam button until steam
does arrive.
- Wait until the on/off pilot light is on
- Fill the reservoir.
- Insert the reservoir and push it fully in.
- Insert an anti-scale cartridge into the
reservoir.
- Change the anti-scale cartridge. Press
the steam button.
- Go to your local dealer.
- Put the dial to the settings ll –
lll.
- Wait for the iron pilot light to go out.
- Press the steam button several times
- Go to your local dealer.
- Fill the reservoir.
- Insert the reservoir and push it fully
in.
- Go to your local dealer.
- Replace the cartridge. Switch the
appliance off and back on. Wait until
the on/off pilot light is permanently
on.
- Wait until the on/off pilot light is
permanently on to use the appliance.