Duux North DXMA10 Mode D'emploi page 8

Power switch
Press the ON/OFF button and the unit will start
1
in cooling mode. The pre-set temperature is
25⁰C on medium fan speed. Only when unplug-
ging the device will it go back to the pre-set
settings.
To turn the unit off press the ON/OFF button
2
again. When the device is turned ON/OFF using
the power button, it will remember the last
setting except timer. Timer is cancelled after
power off and will not be remembered.
Note: The display window shows the ambient
room temperature from 0⁰C to 50⁰C.
Select operation mode
Press the button to select the preferred
operation mode: cooling, dehumidifying or fan.
Cooling mode
When the air conditioner is in cooling mode, it
cools the room. The compressor is then switched
on. When the air conditioner has reached the
desired temperature, it will switch to ventilation
mode. Press the button till the icon lights
up. Press the " - "or" + "buttons to select a desired
room temperature. The temperature can be from
16℃ to 31℃. Press the button to select wind
speed.
14
Dehumidifying operation
In dehumidifying mode the device will turn on the
compressor and starting dehumidifying the room.
Press the button till the icon lights up. The
wind will stay in low speed in dehumidiying mode.
Ventilation mode
In ventilation mode, the air conditioner will only
ventilate. It circulates the air in the room, which has
a cooling effect. The compressor will not switch on
in this mode. Press the button to select wind
speed between 1, 2 or 3.
Setting the timer
The timer can be used to automatically activate
1
the air conditioner between 1 and 24 hours.
This function can only be activated with the air
conditioner is turned OFF. Press and hold the
SLEEP/TIMER button, or press the timer button
on the remote control to activate a delayed
start of the device. You can set the hours by
pressing the "+" or "-" buttons. When turning
the timer off, press and hold the Sleep/Timer
button again and turn the display to "0".
The timer can also be used to automatically
2
shut the air conditioner OFF. This function
can only be activated when the air condition
is turned ON. Press and hold the SLEEP/
TIMER button, or press the timer button on
the remote control. You can set the hours by
pressing the "+" or "-" buttons.
Swing function
After air conditioner turns on, press this key on the
remote control to automatically swing the louver
up and down. By pressing this button again the
swing will stop and the louver will remain in that
position. When the air conditioner is turned OFF,
the louver will automatically close again.
Night mode
When pressing the Night mode button in cooling
mode, the set temperature will increase with 1⁰C
after an hour, another 1⁰C after two hours and
then stays at that temperature. Press the Night
mode button again to cancel the setting.
In Night mode, the ventilation will remain at low
speed. By pressing the Night mode button again,
the ventilation speed will return to the previous
setting.
Note: The unit will shut down automatically
when Night mode is running for more than 12 hours
Note: The night mode is not available while
the machine is operatinng in Dehumidification or
Ventilation mode.
Note: In Night mode, the display will
automatically dim after a few second. Press any key
to reactivate the control panel.
Note: To prolong the lifespan of the compressor,
please wait at least 3 minutes before re-switching on
the device after switching it OFF.
Note: The cooling system will switch off if the
ambient temperature is lower than the set one.
However, the ventilation keeps operating on the set
level. If the ambient temperature rises above the
selected level, the cooling will return to work.
15