Duux Motion DXAW03 Manuel D'utilisation page 5

Power
Touch the button to switch on the device.
After turning on the device, the LED matrix display
will light up for 1 second and shows "Hi!" for 2
seconds after which it will display the current
status followed by the ambient humidity. When
you turn on the device for the first time, it will
activate medium wind speed and turn to low
wind speed after 3 seconds. The humidification
setting will remain active. Touch the POWER button
again to put the device in stand by followed by a
conformation beep. The LED matrix will show "OFF"
and turn off the device in 2 seconds.
Humidity output / wind
speed
When you turn on the device for the first time,
it will activate medium wind speed. Touch the
button to switch between wind speeds. The LED
matrix display will show the corresponding wind
speed in SL (slow), LO (low), MI (medium) and HI
(high).
Hygrostat
Touch the button to set the desired ambient
humidity. When you turn on the device for the first
time, the continuous mode will be activated. You
8
can set the hygrostat in the range between 40%
and 70%. With every touch it will increase with 10%
in the following order: 40% > 50% > 60% > 70%
> CO (continuous). Using continuous mode will
deactivate the hygrostat and the device will run
at continuous speed. When the hygrostat is set
above the actual humidity, the device will operate
in high speed until the desired humidity has been
reached. When the hygrostat is set below the
actual humidity, the device will not humidify. After
setting the hygrostat, the display will show the
ambient humidity.
Timer
Press the button to activate the timer setting.
With every touch the timer will increase with one
hour in the following sequence: 1h > 2h > 3h > 4h
> 5h > 6h > 7h > 8h > 9h > 10h > 11h > 12h
> 00h (off). Once the timer is activated, the device
will automatically shut down after the set timer has
been completed.
Night mode
Press the button to activate night mode. Once
pressed, the LED matrix display will show "ZZZ" for
5 seconds. In night mode, all buttons are disabled
except the night mode and power button. The
device will operate in SL (slow) speed mode.
Press the button again to deactivate night
mode. The LED matrix display will show "ZZZ"
and go back into normal operation mode according
to the hygrostat setting.
Dry run protection
After turning on the device it will check for 1
second if there is sufficient water remaining in the
water tank. In case of lack of water, the device will
activate dry run protection mode and the motor
will stop working. The LED matrix display will show
"NO!" and "Lo" alternating every second. In this
mode, all buttons are disabled except the power
button. Please turn off the device, fill the water
tank and press the power button to switch on the
device again.
Note: It may take a couple of seconds before
the water from the water tank fills up the water
tray. You will hear a water dripping sound, which is
normal. Once the device has recognized the water
tray is filled, it will start operating.
9