CSA LI30RB Guide D'utilisation, D'entretien Et D'installation page 9

•
assembly screws.
•
cover's tabs are aligned and inserted into the stainless steel
aligning and inserting the tabs, the lower part of the duct
cover must be pushing the metal spring inside at all times as
A
•
making sure that all tabs stay inside the respective slots.
When sliding the duct cover upwards, make sure that the
lower part of the duct cover is locked with the metal spring
persons are needed for this operation.
B
• Place lower duct covers using one plastic bracket at each
A
•
making sure that all tabs stay inside the respective slots.
When sliding the duct cover upwards, make sure that the
lower part of the duct cover is locked with the metal spring
A1
are needed for this operation.
rangehood with 4 assembly screws.
Connecting the ductwork
• Install ductwork, making connections in the direction of
• Push duct over the exhaust outlet.
•
tape for an airtight seal.
• Make the same connection in the wall or ceiling vent exit.
B
9
B. Duct tape over seam