SunStar S03+ KIT Manuel D'installation page 21

SITUATION WITH INTERNAL ROTATION STOPPER - BOTTOM BRACKET 70 mm
1
If you use an anti-rotation system mounted
between the engine and the mounting plate,
it is necessary to use a shim of 1 mm also
on the locking ring side (POSITION C) before
placing the black mounting plate.
2
At this point a screw in position B will have
space for the anti-rotation plate of 2 mm,
3
while the other screw will require two washers
of 1mm to properly align the mounting plate.
SITUATION WITH CHAIN GUARD - BOTTOM BRACKET 70 mm
1
If you use a chain guard, you must mount a
thickness of 1 mm in POSITION A,
40
S03+ KIT
Installation manual
1
2
3
1
www.sunstaribike.com
2
subsequently add the fixing plate of the chain
cover of maximum thickness 1 mm (position A)
3
at this point the other side of the bottom
bracket must use a non-rotating plate in
position B (between the motor and
mounting plate)
4
and use 2 washers of 1 mm thickness in
POSITION D for the other screw.
IF THE ENGINE IS IN CONTACT WITH CHIANSTAY
Place the shims provided in POSITION A until the engine is no longer in contact with the
frame. Enter the same thickness of the washers between the mounting plate and motor
(POSITION B & D) to compensate the space used to move away from the frame.
S03+ KIT
Installation manual
2
3
4
41