Aquascape Pro AquaSurge PRO 2000-4000 Instructions Et Entretien page 7

Pompe à débit réglable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Remote Control –
The Remote Control
includes the ability to
turn the pond on, and
adjust the flow of the
pump. Make sure the
switch, on the Receiver,
is in the Remote Control
setting in order for the
Remote to work properly. The Remote Control has an
approximate range of 150 feet. The range of the Remote
may be reduced if there are obstacles between the
Remote and Receiver. Use the included mounting holster
provided to provide a location to store the remote control.
It is recommended to mount the holster in an area that is
protected from the outdoor elements.
1
PLEASE NOTE: The Remote Control and Receiver are
paired together with their own unique frequency. For this
reason Remote Control replacement kits include both
Remote Control and Receiver.
• Battery Installation
1
&
3
1. Remove 4 screws. Remove back cover plate.
2. Place battery in battery compartment.
3. Place back cover and install screws.
• Filter Screens – Do not remove the outer or inner filter
screens while operating the pump. Failure to operate the
pumps without the filter screens will allow large debris to
enter the pump causing the pump to fail voiding the warranty.
• Filter Screen Cleaning – We recommend inspecting
your pump on a regular basis, to make sure it is functioning
properly. If you notice the water flow rate diminish it may
be due to the pump's filter screen becoming clogged with
debris. Always disconnect the power before performing
maintenance on the pump. In many cases the clogged
screen can be cleaned by reaching in the filter and removing,
by hand, any debris from the filter screen. If there is a lot of
debris and/or the debris is difficult to clean you may need to
disconnect the threaded collar on the fitting and remove the
pump from the filter for a more thorough cleaning. A garden
hose can be used to spray off any debris stuck on the filter
screen. Be sure to replace the screen and make sure it is
firmly attached to the pump body before lowering the pump
back into the filter box.
www.aquascapeinc.com |
Decrease
Flow
Increase Flow
On/Off
2
CAN 1-866-766-3426 |
US 1-866-877-6637
• The outer screen is designed to pop off when it is gently
pulled from either side.
• The inner filter screen is threaded on and can be removed
by unscrewing counterclockwise.
• Internal Pump Cleaning – If you have thoroughly
cleaned the filter screens on the pump and still have
diminished flow rates, you will need to remove the water
cover chamber and inspect the impeller rotor assembly.
1
2
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières