Operation And Maintenance - Aquascape Pro AquaSurge PRO 2000-4000 Instructions Et Entretien

Pompe à débit réglable

Masquer les pouces

Table des Matières

Les langues disponibles

• Install the right sized

Multi-Hose Adapter based

on the diameter of the

tubing you are using.

• In some instances the tubing/hose may be tight and

difficult to use with hose fitting barbs. If this is the case

we recommend heating the hose with the use of a hair

dryer or simply dipping the hose for a few seconds in very

hot water. Lubrication can also be used; we recommend

silicone grease or olive oil. We recommend putting the

fitting on the filter before attaching the tubing/hose. Once

the fitting is in place, attach the tubing/hose onto the fitting

with a twisting motion pushing it into place.

• Lower the pump into the skimmer (refer to image) or

Pondless

filter (refer to image) and rotate the Rotational

Ball Output to line up with the tubing. Attach tubing to

the fitting and then tighten a hose clamp (not included) to

secure tubing onto the fitting.

Skimmer application

• If using pipe with a larger

diameter than the smaller

fittings of the Multi-Hose

Adapters, cut off the

smaller section to avoid

any flow restriction.

Pondless

Waterfall application

☎

US 1-866-877-6637 |

• It is recommended to mount the receiver above the ground

on a post, fence or wall.

• Plug the pump into the receiver making sure that blue plug

gasket is in plug port.

• Plug the Receiver into an external GFI-rated electrical source.

In-Line Operation

• The AquaSurge

PRO pump can also be operated "in-line"

by attaching a pipe connected directly from the pond (or

aquarium) to the male-threaded pump inlet. In this case

the water must be pre-filtered of debris in order to prevent

any damage to the pump or impeller. The pump must

NEVER be operated dry without water. This pump is water-

cooled and requires water flowing through the pump at all

times for the pump to operate correctly and stay cooled so

it doesn't overheat.