Pingi CASCADA CHD-W6000D Mode D'emploi page 8

EN
CHD-W6000D - ULTRASONIC HUMIDIFIER
Foam filter: Regularly check the foam filter for dust by opening the filter compartment on the underside of
the device. Rinse the filter under running water if it is dirty.
Ultrasonic element: The ultrasonic element is located in the base. Over time limescale deposits may become
visible on and around this element. If you notice this, it may require descaling. Empty out the base and
pour a mixture 1 part water and 1 part vinegar in the base. Wait for at least 30 minutes before pouring out
the vinegar. You may use a soft brush. Do not use hard brushes or tools, as this may damage the ultrasonic
element. Thoroughly rinse the base before switching on the appliance again.
Exterior: If necessary, wipe off the exterior of the appliance with a lightly dampened cloth.
Ultrasonic
element
Filter
DISPOSAL OF THE DEVICE
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems
available. If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health and well-
being. When replacing old appliances with new ones, the retailer is legally obligated to take
back your old appliance for disposal free of charge.
2021/REV1G1 Copyright © 2020 A-Brand Distributors B.V. All rights reserved.
Foam filter
LIMITED 2-YEAR WARRANTY
ABD guarantees your appliance against material and fabrication faults for two years after your initial
purchase. Should material or fabrication faults be found, ABD will repair or replace the device with a similar
or better-specified product. Damage to the device due to any form of negligence, accident, lack of cleaning
and maintenance, or other use or abuse that can reasonably be considered to be in conflict with the directions
described in these instructions, does not fall under this warranty. Furthermore, legal provisions with respect
to consumer purchases apply. In the event of a fault, we advise you to return the product together with
the original proof of purchase to the store where you bought it. When the defect in the device is caused by
anything other than material or fabrication faults, you may be charged for examination and repair costs.
TROUBLESHOOTING
The device will not switch on. What could be the cause?
- Check if the device is plugged in.
- Check if there is water in the tank.
The device beeps several times and shuts down after I turn it on. What could be the cause?
- There is insufficient water in the tank. Fill the tank.
- The tank is not installed correctly. Install the tank again.
The device is switched on but I do not see any mist. Is there a problem?
- Adjust the humidity level setting. Make sure the humidity setting you picked is higher than the measured
humidity level. See the 'SETTING A HUMIDITY PERCENTAGE' section.
- The base is too full. Lift the tank and empty out the base. Install the tank again. Wait 30 seconds and
switch on the device again.
Water flows down the side of the base after installing the tank. What do I do?
- A few droplets? The base has not been emptied out before the tank was reinstalled. Normally this is
harmless.
- The tank might have been placed on the base in an incorrect manner. Adjust the tank position.
The area around my humidifier is wet? What could be the problem?
- The power level / mist volume setting is too high for your ambient conditions. Choose a lower setting.
- Change the humidity level setting to RH 80% or lower.
The mist smells unpleasant. What is wrong?
- Is the device new? The tank needs to be rinsed before first use.
- Make sure to regularly clean the device as described in the 'CLEANING' section.
The output of mist is lower than before.
- The device has multiple mist levels. Can you set a higher setting?
- The ultrasonic disc might be covered in limescale from hard water. Clean the device with a vinegar
solution, as described in the 'CLEANING' section.
- Check the fan openings. Are the fan openings blocked or clogged?
The filter cartridge smells unpleasant. Do I need to replace it?
- You do not need to replace the filter cartridge. Clean the filter as described in the 'CLEANING' section.
Can I add scents to the water?
- Never add perfumes or oils to the water in the tank or base. Scents can, however, be applied to the foam
filter. To access the foam filter, open the filter compartment on the underside of the device. Please mind
that some essential oils and perfumes contain ingredients that can damage plastic parts.
Distributed by:
A-Brand Distributors B.V.
Unit 303-E1205
Strevelsweg 700-303
3083AS Rotterdam
The Netherlands
+49 (0)2051-4051580 (INT)
www.abranddistributors.com
® ®
Used under license.
www.pingi.com
ID: EC-26589