Safety Notes; Important Notes; Functions; Spare Parts - marklin H0 VT 75.9 Serie Mode D'emploi

Safety Notes

• This locomotive is to be used only with an operating
system designed for it (Märklin AC, Märklin Delta,
Märklin Digital or Märklin Systems).
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one transformer.
• Pay close attention to the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for this
purpose.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or

spare parts.

• http://www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies
the warranty conditions.
8
This specially prepared model is an exclusive version, which
reproduces the condition of the original after many years of
operation in wind and weather.
This special series was only produced in a small quantity.
The artificial weathering was separately applied with care-
ful hand work by experienced artisans. Despite a final fixing
of the colors with varnish, this additional application of color
does not form a homogeneous, hard coating.
Therefore, please handle the model with special care and
avoid, scratching, rubbing, or wiping the surface and the de-
tails. Please do not use liquid cleaners or cleaning solutions.
Please note that the spare parts for this model weathered at
the factory are only available in non-weathered version.

Functions

• Recognition of the mode of operation: automatic.
• Addresses that can be set:
1 – 80 (Control Unit 6021/Mobile Station 60651/652)
(Central Station 60xxx/Mobile Station 60653)
1 – 255
• Address set at the factory: 75
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: VT 75 903 DB
• Adjustable Acceleration delay (ABV).
• Adjustable Braking delay (ABV).
• Adjustable maximum speed.
• Setting the locomotive parameters (address, accelerati-
on/braking delay, maximum speed):
with the Control Unit, Mobile Station, Central Station.