Publicité
Les langues disponibles
Les langues disponibles
Cleaning
Begin with the nozzle 1-2ft away
from the surface and approach
with caution until it reaches the
desired position for overly close
spray may do harm to surface.
WARNING: Do not
connect the machine to
water supplies that are
dirty, rusty, muddy, or corrosive.
(Including window cleaning
liquids, plant foods, or fertilizers
etc.)
Add and use detergent
Install the soap nozzle before
operation.
Note: If necessary, use a funnel
(not supplied)to prevent ac-
cidental overflows of detergent
outside of the tank.
MAINTENANCE
Remove plug from the socket before carrying out
any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each
use. Do not operate it if you find damaged or worn parts.
Contact your supplier or the manufacturer for replacement
parts.
Power cord maintenance
If the supply cord is damaged, it must be replaced by the
10 10
TROUBLESHOOTING
Symptom
Machine does not start
when the switch is in"
I"position.
Machine pressure is
not consistent.
The pressure of the
pump is not adequate
No detergent
Lance leaks
Electric Pressure Washer
See Fig. J
See Fig. K1, K2, K3
Possible causes
Power cord is not plugged in.
.
Socket is defective
GFCI is triggered.
Pump is faulty.
Air in line.
Water inlet adapter is clogged
or dirty.
Water supply is Insufficient.
Water supply is restricted.
Diameter of garden hose is too
small.
Leak or kick in hose .
Wrong nozzle is attached
O-ring needs to be replaced(See
Fig. A1) .
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard
Pump maintenance
Inspect the pump frequently whether any leaking occurs
around the pump seal. If leaking occurs, please contact
service center for repair.
Nozzle maintenance
Remove the nozzle from the lance, then remove any
possible obstructions using the included declogging needle
(See Fig. L).Then use a garden hose to rinse the nozzle by
backwashing
WARNING: Any other servicing should be performed
by an authorized service representative.
STORAGE
1. Disconnect the water source. Turn on the pressure
washers for a few seconds until the remaining water
flows out. Then turn it off quickly.
2. Unplug the power supply and wind power cord on the
lance holder. (See Fig.M)
3. Disconnect the high pressure hose and the garden hose
(not supplied) .Then wind high pressure hose on the
tool. Insert the Wand and lance separately into the Wand
Holder and lance holder. (See Fig. M)
4. Store in a frost free area with a temperature above
0°C(32°F).
Solution
Plug in power cord.
Check or replace plug, socket, fuses.
Press reset on GFCI plug.
Contact service center .
Remove the nozzle, turn on the machine for a while and
install the nozzle back.
Remove the adapter, rinse it with water and put is back.
Open water source completely.
Check If the water hose kinks or leaks.
Replace with right garden hose .
Replace hose or untie kinks in hose.
Attach the soap nozzle
Replace o-ring .If the problem is not solved ,contact service
center to buy a new lance.
EN
Publicité
