Beta 1895G Mode D'emploi page 15

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• Use the arrows to select the required language and press the
CONNECTING COMPONENTS TO BE CLEANED IN ULTRASONIC TANK:
• Petrol/LPG injectors
Use the "injector" connectors and a cord suitable for connecting to the injector, being careful not to
immerse the power connection in the ultrasonic cleaning tank.
CAUTION: If the contacts of the injectors to be tested have become oxidized, the main cable will be
damaged.
• PWM devices
Use the "PWM" connection and a cord suitable for connecting to the component, making sure to locate
the pins in the connector the active part of the component refers to.
NOTE 1: Before supplying power to the component, check on the wiring diagram of the motor vehicle
which pins must be connected.
NOTE 2: Make sure not to immerse the power connection in the ultrasonic cleaning tank.
PROCEDURES:
The electric control generator is used to control several components during ultrasonic cleaning
operations, in order to remove deposits which can hardly be reached by ultrasonic cleaning.
Three options are available, each relying on several parameters which can be set and are saved on
the electric control generator.
• Press the key and use the
ULTRASONIC CLEANING
BETA 1895G - REV 1.0
ULTRASONIC CLEANING
BETA 1895G - REV 1.0
arrows to select the required item.
EN I
key to confirm.
15