Baby Trend SMART STEPS AC01A Serie Manuel D'instruction page 8

ASSEMBLY
BATTERY INSTRUCTION
5 • Reference the diagram
below. The light and sound
board requires 3 AAA
batteries. Reference
(Fig. 5) for battery
installation. Unscrew
the battery door and pull
outward. Install batteries as
shown. Re-install battery
door and push until it clicks
into place.
WARNING:
• Requires three AAA (LR03) batteries (not included) for toy operation.
• Non-rechargeable batteries are not to be recharged.
• Different types of batteries or new and used batteries are not to be
mixed. Batteries need to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not be short-circuited.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
BATTERY DOOR
Light and Sound Board Diagram
NOTE: To activate the light and sound
board, use the ON / OFF Switch.
13
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 5
Place / remove
the screw
Door
ON/OFF
Power Switch
TOY ATTACHMENTS
6 • Place toys in this order as
shown. Toys must be properly
attached before use (Fig. 6a).
NOTE: ONLY the spinning
ball, bendable rattle, and toy
rings are interchangeable.
• All toys must be aligned with
their single or double tab
housings on the activity center
tray (Fig. 6b).
Set the toy base in alignment
with the tabletop fitting. From
underneath the tabletop push
the lock up and turn it left
to lock.
• Use the diagram below to lock the toys onto the tabletop.
(1) Push the tab up and rotate it left to lock. (2) Rotate the
tab right to release the toy. (3) Always put the small tab lock
back into the tabletop when not in use.
Align
1
2
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 6a
Fig. 6b
TOY ATTACHMENT
Align
3
14