Baby Trend SMART STEPS AC01A Serie Manuel D'instruction page 6

ASSEMBLY
SWIVEL SEAT MODE
1 • Insert each leg into the
underside of the tabletop
(Fig. 1a).
NOTE: Ensure that the pin
clicks into position.
• Align the seat to the
center opening and press
it down firmly. The seat
must completely click into
to the tabletop (Fig. 1b).
NOTE: Rotate the seat
to ensure the swivel
function is active.
• To attach and dettach the
seat cover, see step 7.
SEAT REMOVAL
2
• To remove the seat, use
the edge of the seat to lift it
off the tabletop (Fig. 2).
9
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
"Click"
Fig. 1a
Fig. 1b
lift from edge
Fig. 3
ADJUSTABLE PLATFORM SET UP
3 • Underneath the tabletop
pinch and pull out the 3
small straps (Fig. 3a).
Underneath the platform
unhook the 3 adjustment
plates, pinch and pull out the
3 large straps (Fig. 3b).
• With the smooth side up,
align the pointed side of
the platform to the front
of the tabletop. Hook the
adjustment plate to small
strap using the lowest hoop
(Fig. 3c). Repeat for the rear
straps.
• To adjust the height, unhook
the adjustment plate and put
it through the next division of
the strap (Fig. 3d).
• ATTENTION: Always secure
the straps when the platform
is not in use. Refer to step
4c and 4d.
Fig. 3c
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 3a
Fig. 3b
Fig. 3d
10