Installing Your Power Supply - RocketFish RF-700WPS Guide De L'utilisateur

• 100% Hi-pot and burn-in tested
• Supports 12-16 SCSI hard drives
• Components include:
Output cables
3.4 inches
(86.0 mm)

Installing your power supply

To make sure you connect your power supply correctly, check your
motherboard and graphics card manuals for compatibility before
connecting RF-700WPS to any of your devices.
To install your power supply:
Check your local AC voltage before installation (115 VAC voltage is for
1
USA, Japan, and so on, and 230 VAC voltage is for Europe, South East
Asia, and many other countries).
Caution:
Be sure to connect the PSU (Power Supply Unit) to local input AC voltage only. Setting
the incorrect voltage can damage the power supply and connected equipment, and
may void your warranty. The RF-700WPS is compatible with 115VAC and 230VAC
input voltage.
Turn off your computer, then unplug the power cord from your old
2
power supply.
Open your computer case following the directions provided in your case
3
manual.
Disconnect all PSU connectors from the motherboard and the
4
peripherals devices such as case fans, HDD, FDD, DVD, CD-ROM, and so
on.
5.5inches
(140.0 mm)
5.9 inches
(150.0 mm)
Fan
4.7 inches
12 cm
AC socket
Power switch
RF-700WPS 3