Bimar DEU314 Notice D'instructions page 41

Drainage.
The water can be drained:
3. Via the tank (2)
the internal float puts the appliance on standby, and the LED in button
Remove the tank without spilling any water, empty it and dry it. Check that the
float is free to move and replace the tank correctly in its seat (the LED remains on
and steady).
4. Continuous
The continuous drainage spout, on the back of the appliance has a rubber cap:
remove the cap and attach the rubber tube with 16 mm internal diameter and max
0,30 m length (comes supplied with some models). Make sure the connection does
not leak. Check that the drain is at a lower height than the spout and that the whole
tube is sloping evenly and that it is lower than the spout.
Do not remove the water tank from its place.
If continuous drainage is not in use, remove the drainage tube and close the spout
again with the rubber cap.
Filter
The air inlet grille has a filter which traps dust: it is placed internally and to access it, it
is necessary to remove the tank. It is accessible from the bottom - slide downwards
gripping the central clasp with two fingers. See the paragraph below for filter
maintenance. Return it to its seat.
Handle
The top part has a handle on the side for transportation.
USE
Before each use, make sure that:
-the appliance is in good condition
-that the mains cable is not damaged
-that the tank is empty, and fully in place.
-that the water drainage spout is properly closed with the cap whenever the tank is
used, or the drainage tube is inserted properly and in place whenever continuous
drainage is used.
•
Connect the plug to the power socket.
•
Turn on the appliance by pressing
the instructions above.
.
The water condensate is collected in the tank and when it is full,
and activate the desired function, following
flashes.