Scope Of Delivery - Dometic BUTTNER MT 90 Instructions De Montage Et De Service

• Do not lay the 230 V mains cable and the 12 V
DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily
kinked.
• Fasten the cables securely.
• Do not pull on the cables.
Operating the device safely
D
DANGER! Failure to obey these warn-
ings will result in death or serious
injury.
Electrocution hazard
• Do not touch exposed cables with your bare
hands.
!
WARNING! Failure to obey these
warnings could result in death or
serious injury.
Risk of injury
• At the beginning of each trip and at regular inter-
vals during each trip, check that the solar panels
are firmly attached to the roof. An incorrectly
mounted solar panel can fall off during the jour-
ney and injure other road users.
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Explosion hazard
• Do not operate the device under the following
conditions:
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a risk of explosions
A
NOTICE! Damage hazard
• Avoid heavy shocks and vibration while driving.

Scope of delivery

MT 90, MT 130, MT 210, MT 130 CDS,
MT 210 CDS
Item in
fig. 1,
Designation
page 3
1 Solar panel
2 Side roof mounting support
3 Blind plug
10
Item in
fig. 1,
Designation
page 3
4 Cable gland
5 Roof duct
6 Solar charger
7 Adhesive kit
8 Outdoor cable (2 x 2.5 mm²)
9 Indoor cable (2 x 4 mm²)
10 Temperature sensor
11 EBL cable kit
12 Cable connector
13 Screw AW20-A2-3,9X32
– Installation and Operating Manual for
the solar charger
MT 180-2, MT 260-2, MT 420-2,
MT 260-2 CDS, MT 420-2 CDS
Item in
fig. 1,
Designation
page 3
1 Solar panel
2 Side roof mounting support
3 Blind plug
4 Cable gland
5 Roof duct
6 Solar charger
7 Adhesive kit
8 Outdoor cable (2 x 2.5 mm²)
9 Indoor cable (2 x 4 mm²)
10 Temperature sensor
Qty.
11 EBL cable kit
1
12 Cable connector
2
1
4445103707
Qty.
1
1
1
1
1
1
1
1
2
8
1
Qty.
2
4
1
1
1
1
1
1
1
1
1
2