T&S B-7161-C Instructions Pour L'installation Et La Maintenance page 5

General Instructions
• To disable ratchet lock, see section in servicing on "RATCHET LOCK REPLACEMENT /
REMOVAL. "
TENSION ADJUSTMENT
CAUTION: Always leave at least 1-2 turns between full extension and when the CAUTION: Always leave at least 1-2 turns between full extension and when the
spring is wound tight. If entire hose cannot be pulled out, decrease tension until spring is wound tight. If entire hose cannot be pulled out, decrease tension until
full extension is possible. Failure to test for adequate spring revolutions can full extension is possible. Failure to test for adequate spring revolutions can
cause damage to reel. Hazards or unsafe practices may result in minor personal cause damage to reel. Hazards or unsafe practices may result in minor personal
injury or product or property damage. injury or product or property damage.
Reel is shipped pre-tensioned at factory.
TO ADJUST TENSION
• Pull spray valve and hose out until the ratchet
goes through two sets of "clicks".
• Remove shroud screws and shroud (Fig.1) and
loosen top screw (Fig.2).
• Remove spray valve. Do not pull hose while
removing valve or shroud. This may cause
the hose to retract and cause injury
or damage property.
• Push hose through hose guide.
TO INCREASE TENSION (Fig.3)
• Pull hose out from the shroud opening.
• Loop hose back through and around hub inside
of case until the hose comes back through shroud opening.
• Place hose end through hose guide and reattach spray valve.
• Pull hose out until "clicking" stops and slowly retract hose until spray valve rests
against hose guide.
• Reattach shroud.
TO DECREASE TENSION (Fig.3)
• Pull hose out from the shroud opening.
• Un-loop hose back through and around
hub inside of case until the hose comes
back through shroud opening.
• Place hose end through hose guide and reattach spray valve.
• Pull hose out until "clicking" stops and slowly retract hose until spray valve rests
against hose guide.
• Reattach shroud.
Repeat either procedure until desired tension is achieved.
shroud
Figure 1
Figure 2
Figure 3
increase
5
screws
top screw
decrease