gas. Installation must conform to local codes, or in
their absence, with the standard for the Storage and
Handling of Liquefied Petroleum Gases ANSI/NFPA 58
and the Natural Gas and Propane Installation Code
CSA B149.1.
l ) Gas supply connections should be checked by using a
50/50 soap and water solution. Never use a flame to
check for gas leaks.
m ) Locate LP cylinder at least 6 ft. (183 cm) (10 ft./305 cm
in Canada) from the heater, and do not direct heater
discharge towards the LP cylinder unless it is at least
20 feet (610 cm) from the heater.
n ) Use only the regulator and hose assembly provided
with this heater. Inspect the regulator/hose assembly
prior to each use of the heater. If there is excessive
abrasion or wear, or if the hose is cut, replace it with
the proper assembly shown in the parts list, prior to
using the heater.
MANIFOLD, MINIMUM, AND MAXIMUM INLET PRESSURE
Manifold
Minimum
Maximum
5) Service
a ) Do not tamper with the heater. Have a qualified
service person make any necessary adjustment or
repairs.
b ) Use only original equipment parts. The use of
alternate or third party components can cause unsafe
operating conditions and will void your warranty.
Additional Safety Information
ADDITIONAL SAFETY WARNINGS
WARNING: Risk of indoor air pollution!
•
The products described in this manual are propane
direct-fired, forced air heaters. Propane forced air heaters
are primarily intended for use for temporary heating of
buildings under construction, alteration or repair. Direct-
fired means that all of the combustion products of the
heater enter the heated space. This appliance is rated
at 98% combustion efficiency, but does produce small
amounts of carbon monoxide.
DANGER: Carbon Monoxide Hazard: This heater
produces carbon monoxide, which has no odor.
Burning the heater in an enclosed space can kill its
occupants. Never use the heater in enclosed spaces
such as a tent, a camper, any vehicle or recreational
vehicle (RV), enclosed shelter, or any other enclosed
areas.
DANGER: Carbon monoxide poisoning may lead
to death.
•
Carbon monoxide is toxic. Humans can tolerate only small
amounts of carbon monoxide and so precautions should
be taken to provide proper ventilation. Failure to provide
proper ventilation in accordance with the instructions in
this manual can result in death. People with breathing
11" / 279 mm W.C.
5 PSI (34.5 kPa)
Bottle Pressure
problems should consult a physician before using this
heater. Early signs of carbon monoxide poisoning resemble
the flu. Symptoms of improper ventilation/carbon
monoxide poisoning are: Headache, Dizziness, Nausea,
Dry Mouth, Sore Throat, Burning of Nose and Eyes.
•
If you experience any of these symptoms, get fresh air
at once! Have your heater serviced and check for proper
ventilation. Some people are more affected by carbon
monoxide than others. These include: pregnant women,
those with heart or lung problems, anemia or those under
the influence of alcohol or at high altitudes.
WHAT TO DO IF THE SMELL OF GAS IS PRESENT:
•
DO NOT attempt to light the heater.
•
Extinguish any open flame.
•
Shut off gas to heater.
•
If odor continues, contact your local gas supplier or fire
department.
•
DO NOT touch or use any electric switch or any electric
device that can cause a spark.
•
Immediately call your gas supplier from a neighbors
phone. Follow the gas suppliers instructions.
•
If you can not reach your gas supplier, call the fire
department.
•
Service must be done by a qualified service agency.
WARNING: This product contains chemicals,
including lead, which are known to the State of
California to cause cancer and birth defects or other
reproductive harm. For more information go to www.
P65Warnings.ca.gov.
WARNING: Caution! Hot while in operation. Do
not touch. Keep children, animals, clothing and
combustibles away from heater.
This heater is designed and approved for use as a
construction heater in accordance with Standard
ANSI Z83.7-2011/CSA 2.14-2011. CHECK WITH YOUR
LOCAL FIRE SAFETY AUTHORITY IF YOU HAVE ANY
QUESTIONS ABOUT APPLICATIONS. Other standards
govern the use of fuel gasses and heating products
for specific uses. Your local authority can advise you
about these.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
UNPACKING
1 . Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to inlet
connector and hose / regulator assembly for storage.
2 . Remove all items from carton.
3 . Check all items for shipping damage. If the heater
is damaged, promptly inform the dealer where you
purchased the heater.
ENGLISH
3