Indexa GA50 Mode D'emploi page 41

telecommunication lines when fitting the
device. Danger to life and risk of injury
and damage.
• Never expose the device to fire, heat or to
temperatures of over 50° C for any length
of time. Danger to life from explosion.
• Make sure that your hearing is not
exposed to the loud alarm signal for any
length of time. This can cause serious
damage to the hearing.
• Make sure that the alarm signal is not
triggered close to the ears. This can
cause serious damage to the hearing.
• Handle the connecting cable with care.
Install it so that it cannot get damaged
and does not create a stumbling hazard.
Otherwise there is danger to life and a
risk of injury and fire.
What to do in the event of a gas leak
Please proceed as follows if the gas alarm sig-
nals a gas leak or if you smell gas:
• Do not ignite any naked lights. Extinguish
any burning tobacco or candles etc.
immediately.
• In the event of a gas leak, do not switch
any electrical devices (light switch, torch,
door bell, telephone, intercom, or other
electric consumers) on or off.
• Do not under any circumstances discon-
nect the gas alarm from the power supply.
• Immediately warn all people at risk and
make sure that they evacuate the area to
safety.
• Shut off the gas supply on the main gas
tap or bottle valve.
• Open the windows and doors and air the
room, the house, the caravan, etc. thor-
oughly.
• Note on airing rooms: certain gases (pro-
pane and butane) are heavier than the
ambient air, and some are lighter (meth-
ane). When airing, please make sure that
the intake of air is suitable for the proper-
ties of the gas.
• If leaking gas is indicated constantly or
repeatedly, please contact your energy
provider. Do not use the telephone or any
other electrical device near or around the
gas leak to notify the provider.
• The gas leak must only be dealt with by a
qualified and authorized expert.
m
Caution
• If you are uncertain which type of gas you
use or you have problems installing the
gas alarm you must have the device
installed by a suitably qualified person.
• Only connect the device to 12 V DC!
Before plugging in the mains adapter make
GB
39