Publicité
Les langues disponibles
Les langues disponibles
6- USE INSTRUCTIONS
6.1 – Control
-» The electrical control of the concrete mixer is done by the general switch, the machine possesses two buttons, green to start and red to stop.
6.2 - Risks of use
-» Do not insert any part of the body inside the drum.
-» When loading the concrete mixer with a shovel, do not introduce it in the drum
-» Inserting an object in the drum whilst in function may cause serious accidents; for the mixers can grasp the object making it twirl in the
operators' direction.
-» NB - Any use of this equipment besides the purpose for which it has been designed can constitute a threat to the physical integrity of the
operator and to whoever is close by.
6.3 - Aid in case of damage
DAMAGE
The machine does not work
(Electrical Engine)
The wheel does not turn or turns with effort
NB. Do not open the back cover of the concrete mixer with an electrical engine, before certifying that the power supply has been interrupted.
6.4 - Repairing
-» The repair of this machine should be done by qualified technicians in order to prevent any danger.
6.5 - Individual Protection Equipment
-» The operator of this machine should use gloves, eyeglasses and auricular protection.
7- MAINTENANCE
7.1 - Periodic maintenance
Clean the inside of the tank properly with water once it is used, avoiding any traces of cement, as any traces left by it will harden
and stick more each time it is used until it can no longer be used.
No golpearla cuba para limpiarla.
Check the condition of the transport wheels.
Depending on the working conditions, it is recommended to extend the life of the concrete mixer, so that the precision
elements are engazés.
Check that the drive belt is correctly tensioned (that it does not slip on the motor pulley).
The tank crown should not be greased when protected.Clean with water against the motor or electrical components.
Any work on the machine must be carried out by a qualified person, stop the motor and be disconnected from the power
supply.
Do not lubricate the pinion and the crown of the concrete
mixer. You can win the concrete mixer.
CAUSE
Power supply interrupted
Lack of lubrication
¡ WARNING!
10
RESOLUTION
Disconnect the machines plug and verify if there is
electrical current. Verify the existence of any damage
in the cable linking, the plug or the plug linking.
Place some oil drops in the yokes' rear socket.
Lubricate with mass the yokes' front socket.
Publicité
