BoomToneDJ UHF-10 Série Mode D'emploi page 11

USING THE UHF10&20 - HANDMIC VERSION
1 / Remove the packing material, and keep it.
2 / Plug the power supply adaptor into the power supply connector on the back
side of the receiver .
3 / Connect the audio connector.
Note : For the dual receiver UHF-20R, you can use the XLR balanced audio out-
put ( one per channel) , or the mix TRS output ( unbalanced output)
4 / Fully extend the antenna.
5 / Open the handmic battery cover and insert the battery.
6 / Turn ON the receiver. The power indicator will light up.
7 / Turn ON the handmic, if the low bat. indicator is always lighted, your battery
is defective.
8 / As soon as handmic is turn ON, RF indicator on receiver must light up.
9 / Adjust the volume on the receiver, you are now ready to use your microphone
wireless system.
USING THE UHF-10&20 - HL VERSION
1 / Remove the packing material, and keep it .
2 / Plug the power supply adaptor into the power supply connector on the back
side of the receiver .
3 / Connect the audio connector.
Note : For the dual receiver UHF-20R, you can use the XLR balanced audio output
( one per channel) , or the mix TRS output ( unbalanced output)
4 / Fully extend the antenna .
5 / Open belt pack battery cover and insert the battery.
6 / Connect the headset (or lavalier mic) cable to the belt pack.
7 / Turn ON the receiver. The power indicator will light up.
8 / Turn ON the transmitter, if the light is always lighted, your battery is defective.
9 / As soon as handmic is turn ON, RF indicator on receiver must light up.
10 / Adjust the volume on the receiver, and on the transmitter .You are now ready
to use your microphone wireless system.