Publicité
Les langues disponibles
Les langues disponibles
• Study, understand, and follow all instructions before operating this device.
• No alteration shall be made to this device.
• Always wear protective gear when operating hydraulic equipment.
• Keep hydraulic equipment away from flames and heat. Hydraulic fluid can ignite and burn. Do
not operate if leaks are detected.
• Burst hazard exists if hose or connection pressure exceeds rated pressure. Do not exceed the
rated capacity of this device.
• Inspect hoses and connections for damage prior to use.
• Do not subject the pump and its components to shock loads.
• Do not connect to application which can return more oil to the reservoir than the pump reservoir can hold.
• To reduce the risk of personal injury and/or property damage, hydraulic connections must be securely fastened
before building pressure in the system. Release all system pressure before loosening any hydraulic
connection in the system.
• Always monitor pressure, load or position using suitable equipment. Pressure may be monitored by means
of an optional manifold and gauge. Load may be monitored by means of a load cell and digital indicator.
• To reduce the risk of personal injury and/or property damage, ensure that the rated working pressure of each
pressurized attachment be equal to or greater than the rated working pressure developed by the hydraulic
pump.
• Always check connections before using. Alteration of these products is strictly prohibited. Use only those
adapters and attachments provided and approved by the manufacturer.
• Failure to heed these markings may result in personal injury and/or property damage.
BEFORE USE
1. Familiarize yourself with the specifications and illustrations in this owners manual. Know your pump, its limitations
and how it operates before attempting to use. Refer to specification chart for details of oil port thread size, usable
oil capacity, and more. If in doubt, contact Omega Technical Service (888) 332-6419.
2. Replace shipping plug (red color) with air vent plug (black color) before use.
3. Air Connection: Remove plastic cap, secure air supply threaded port connections with high grade, non-hardening
pipe thread sealant. Teflon tape can be used if only one layer of tape is used and it is applied carefully, two threads
back, to prevent the tape from being introduced into hydraulic system, which could cause jamming of precision-fit
parts. Tighten fittings. Air input port is designed to fit popular 1/4" NPT air nipples (not included). Ensure that your
air source can dedicate 7.8CFM @ 110~175 PSI to each pump operated.
4. Hydraulic Connection: Clean all areas around the oil port of pump and application. Inspect all threads and fitting
for signs of wear or damage and replace as needed. Clean all hose ends, couplers and union ends. Remove the
manifold plug, secure threaded port connections with high grade, non-hardening pipe thread sealant. Teflon tape
can be used if only one layer of tape is used and it is applied carefully, two threads back, to prevent the tape from
being introduced into hydraulic system, which could cause jamming of precision-fit parts. Tighten fittings, then
connect to application.
!
WARNING
3
Publicité
