Troubleshooting; Troubleshooting Steps - iHealth Lite Mode D'emploi

ΠThis device may not cause interference, and
 This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
14. Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.

TROUBLESHOOTING

Issue
Bluetooth icon on the Scale
display won't stop flashing.
Scale display shows "Lo. "
Scale displays shows "Er 0. "
Scale display shows "Er 1. "
Scale displays "Er 2. "
Scale displays "Er 4. "
Scale displays "Er 9. "
Possible Cause
Bluetooth connection failed.
Battery level is low.
The Scale failed to initialize.
Maximum weight has been
exceeded.
The Scale can't capture a
steady reading.
Bluetooth connection error.
Scale memory access error.
9

Troubleshooting Steps

Make sure Bluetooth is
enabled, the Scale is turned
on and the app is running.
Restart the mobile device
and try again.
Change the batteries.
Remove the batteries,
wait for one minute,
then reinstall them.
The maximum weight
allowed is 400 lb/180 kg.
1. Allow the Scale to shut
off completely before trying
again.
2. Place feet on the center of
glass platform and stand still.
Reset the Bluetooth
connection by turning it off
and back on again.
Remove the batteries, wait
one minute, then reinstall.