GiiNii Audiobulb AB-S10 Manuel page 8

EASY SETUP
d) Find the pairing hole located on the edge of speaker grill. Insert a small paperclip through the
pairing hole and press the pairing button located inside the speaker. Repeat this step for all
speakers to be paired to the desired zone.
'
EXAMPLE: If you d like to use two AudioBulbs in Zone 1, please repeat the above step on both
AudioBulbs before proceeding to step e (pressing the PAIR button on the docking station).
Stereo Channel Setting: The first paired AudioBulb is automatically configured to the Left
channel. The second paired AudioBulb is automatically configured to the Right channel. If two
AudioBulbs are paired at the same time, the channels will automatically set to Left for the first
paired AudioBulb and Right for the second paired AudioBulb
e) Press the PAIR button on the docking station again to complete setup. The indicator lights will
blink as shown below to indicate successful pairing.
To set second zone, repeat all steps but select different zone in step b to pair.
Mono Sound Setting: To set an AudioBulb to MONO sound output, please go thru the entire
process of steps a-e for each AudioBulb individually. This is helpful when you are only installing
one AudioBulb in a room and want the entire sound track to play out of that AudioBulb.
.
English
13
EASY SETUP
To reset paired channels and re-designate AudioBulbs:
a) Press and hold the pairing button on bottom of docking station for 4-6 seconds erase all prior
set pairs.
b) All 4 LED indicators on docking station will blink in sequence.
c) All 4 LED indicators on docking station will fast-blink at the same time (all pairing erased at this
point).
Note:
·If you wish to add more AudioBulbs to predefined Zone 1, repeat steps above and choose Zone 1
on the remote.
·1 and 2 paired AudioBulbs are automatically set to Left and Right channels respectively. st nd
·In case pairing is not successful, press and hold pair buttons on docking station for 4~6 seconds
to reset the system then repeat above instructions.
·If you have a wireless router in your home, it is recommended that the docking station and the
wireless router are at least 10 feet apart to avoid any potential signal interference.
English
14