Pairing - GiiNii Audiobulb AB-S10 Manuel

EASY SETUP
4. Slide the battery holder into the remote control.
• Failure to replace the battery in the correct manner may damage the battery and the remote.
• Use only the specified battery type.
• Recycle or dispose used batteries properly according to local guidelines and regulations.
• The batteries are highly flammable, keep away from excessive heat or moisture.
• If the battery is completely drained or not in use for extended period of time, remove the
battery to prevent leakage.

4. Pairing

The AudioBulbs are preconfigured to Zone 1 for convenience. In some rare occasions, you may
need to re-establish the wireless connection. Please make sure all devices are connected to power
and follow below simple steps.
To set up/add AudioBulbs to
a) Press the PAIR located at the bottom of the docking station.
b) Point remote control at the docking station and press down on Zone 1 or Zone 2 button, and the
connect indicator light on docking station will flash rapidly.(AUX indicator will flash when pairing
Zone 2).
c) Make sure the AudioBulb is securely installed securely in an light socket and powered on.
English English
11 12
EASY SETUP
either zone :
Pairing Zone 1 Pairing Zone 2