Garland MONTANA 516 Manuel D'instructions page 39

- Do not cut branches or pieces of wood that could
change position during the duration of the cut.
- Maintain the chain in a good state.
- Only work if the chain is sharp and properly tensed.
- Never position yourself in the cutting area of the
chain.
- Only use bars and chains recommended by the
manufacturer. The use of other bars and/or chains
can cause the chain to break and/or back kicks.
- Follow the manufacturers instructions about
sharpening of the chain and general maintenance
of the chain. If the minimum level in the chain
calibre is surpassed it will cause an increase in
back kicks and back pulls.
2.6. MAINTENANCE
Take your machine for periodic revision to a qualified
after sales dealer and only use original spare parts
and accessories. This will guarantee that the security
measures of this machine can always be complied
with.
39/172
English