Charge The Built-In Battery - JVC XA-HD500B Guide Rapide

Charge the built-in battery

The battery is undetachable. When it
needs to be repaired, consult your
dealer or JVC Service Center.
1 Connect the supplied AC power
adapter to the cradle.
2 Plug it into an AC outlet.
3 Place the XA-HD500 in the cradle.
• Make sure that the connectors are
firmly attached.
• The battery starts charging.
8
When charging the battery while the
power is off: If the battery is fully
consumed, the battery indicator will not
be displayed at first (for about 1 minute)
after starting charging the battery.
• It takes about 3.5 hours for full charge
To an AC outlet
• The built-in battery may eventually
• If you connect the XA-HD500 to your
NOTES:
when the battery is used up. The time
required for charging varies according
to the remaining battery power and the
current operational status of the XA-
HD500.
need to be replaced. If the battery
power is consumed too quickly after
fully being charged, it is recommended
to replace the battery. To replace the
battery, consult your dealer or JVC
Service Center.
PC with the USB cable, you can also
charge the battery (except when the
PC is in the stand-by mode). However,
It is recommended to charge the
battery through the cradle and the AC
adapter.