Installation - Sunbeam SBWC011A1B Guide D'utilisation Et Soins De Propriètaire

Part Identification
1. Glass Door
2. Control Panel
3. LED Display
4. Interior Light (not shown)
5. Wine Racks
6. Door Hinge Cover
7. Adjustable Feet
1 2
7
I N S T A L L A T I O N
6
3
/ °F
5
Location Requirements
• Select a location with a strong, level floor.
• Allow 5 inches of space between the back of the
appliance and any adjacent wall.
• Avoid direct sunlight and heat. Direct sunlight may
affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
• Do not use this appliance outdoors: This
appliance is intended for household use only. Do
not attempt to operate or store this appliance
outdoors.
• Do not build this appliance into an enclosure: This
appliance is designed for a free-standing
application only and is not intended to be "built-in".
Before Using your Wine Cooler
• Remove the exterior and interior packaging.
• Check to be sure the following parts are included:
• 3 Slide-out shelves.
• Before connecting the appliance to the power
source, let it stand upright for approximately 2
hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water
using a soft cloth.
• Place your appliance on a floor that is strong
enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
3