FITFIU FITNESS RA-100 Manuel D'instructions page 36

MAINTENANCE
• Make sure you have turned off the appliance and disconnected the plug before servicing.
• Do not clean with abrasives or solvents to avoid damage to finishes.
• Be careful not to allow excessive moisture to enter the display panel as it may damage the display and create an
electrical hazard.
• Keep the equipment, especially the display console, out of direct sunlight to avoid damage.
•
To clean around the plug and control panel use a soft, dry cloth, never use wet cloths.
• Do not insert the cleaner into the appliance to avoid hazards.
• Do not use the air oar in wet or dusty environments as this can lead to leakage or mechanical failure. Use this
product on a flat surface.
TRANSPORT AND STORAGE
To move the machine, lift the rear stabilizer until the front stabilizer transport wheels touch the ground. With the wheels
on the ground, easily transport the machine to the desired location.
To save space, fold the slide rail (n° 79). Slightly raise the slide rail (n° 79) where it joins the main frame (n° 49). With the
other hand, remove the traction pin (n°67) (Figure A). Fold the slide rail (No. 79) to the vertical angle. Insert the drag pin (n°
67) into the fixing table and through the slide rail (n° 79) to secure the slide rail (n° 79) (Figure B).
49
Store equipment in a clean, dry indoor environment. Never leave or use the unit outdoors. Make sure the main switch is
turned OFF ("O") and that the power cord is disconnected from the mains.
79
Figure A
67
79
79
49
Figure B
79
49
67
36
67
79
79
49
67