AMIX AFF 2 Serie Manuel Utilisateur page 27

REAR PANEL
Câblage avec un SNA Rack :
to connect to SNA R A connector
3 ) RJ45 opto mos relay output connector corresponding to alarm level exceeding.
GPO1
GPO2
Internal OPTO MOS wiring
CMD 2
CMD 1
4 ) RJ45 connector to ethernet (LAN)
5 ) B type USB connector for firmware upgrade only.
MESURING RANGE
With A weighted, 10 minute Leq, 5 minute Leq, 1 minute Leq and 1 second Leq range is from
60 dB(A) to 122 dB(A).
However, it is possible, as an option, to measure from 40 dB(A) to 102dB(A).
With C weighted, peak level range is from
However, it is possible, as an option, to measure from
ERROR LISTING
Error listing which can be displayed by control display (B).
E2 : CAP 20 sensor link defect
AMIX - AFFseries-2
XLR F plug
(see SNA manual page 15)
1
+
SENSOR
-
V+
OPTO MOS 2
OPTO MOS 1
8
1
2
3
V+
4
5
6
7
8
-
3
3
2
1 2
1
Leds GPO1 and GPO2 display GPO1 and GPO2
state, and allow to recover the equipment IP address.
(see page 10)
Note :
Each OPTO can be considered as a relay and
offers all the advantages (alternative signals, no
wiring). Current limit is fixed at 200mA.
70 dB(C) to 132 dB(C).
50 dB(C) to 112 dB(C).
27
AFFseries-2 plug
-
+
shielded cable
Next
ENGLISH