Publicité
Les langues disponibles
Les langues disponibles
Delayed Watering (when the
watering must start at a given
time):
1. VERY IMPORTANT: To program any
watering mode, always start with
the RUN TIME rotary knob in ON and
then set the FREQUENCY rotary knob
to RESET.
2. The red lamp blinks. (If the red lamp
does not blink, turn the FREQUENCY
rotary knob to any position and set it
back to RESET).
3. Set the RUN TIME rotary knob to the
required position (1, 3, 5, 10, 15, 20,
30, 60, 90 or 120 min.) to select the
watering duration.
4. Press the YELLOW button as many
times as hours we want to delay the
watering. When the YELLOW button
is pressed, the blinking red lamp
triggers a GREEN light flash. This
means that the watering has been
delayed 1 hour. Press the YELLOW
button 5 times for 5 hours delay, and
the GREEN light will flash 5 times..
ATTENTION: If step 4 is not made while
the red lamp blinks, the timer will not
memorise the previous steps. Therefore,
the watering sequence must be
programmed from step 1 in paragraph
Programming.
5. After selecting the delay time, set
the FREQUENCY rotary knob to the
required position (1, 2, 3, 4, 6, 8, 12,
Instructions for configuration
24 (once a day), 48 (once every other
day), 72 hours (once every 3 days) or
Week (once a week).
6. Listen to a "CLICK" sound meaning
the timer valve has opened and the
GREEN light flashes to confirm the
selection made.
After these steps, the timer must start
watering during the time set by RUN
TIME and must repeat the irrigation
as per the setting of the FREQUENCY
knob.
Programming example
Water 2 times a day for 20 minutes
1. Set the RUN TIME rotary knob to
ON and then the FREQUENCY rotary
knob to RESET.
2. The red lamp blinks. (If the red lamp
does not blink, turn the FREQUENCY
rotary knob to any position and set it
back to RESET).
3. Set the RUN TIME rotary knob to
position 20 to select the watering
duration.
4. With the red lamp blinking, set the
FREQUENCY rotary knob to position
12.
5. Listen to a "CLICK" sound meaning
the timer valve has opened and the
GREEN light flashes.
ATTENTION: If steps 3 to 4 are not
made while the red light blinks, the
timer will not memorise the previous
steps. Therefore, the watering sequence
7
GB
Publicité
