Publicité
Les langues disponibles
Les langues disponibles
For bass guitars with standard single-coil pickups we suggest you use the 0 dB input; for
active or extremely 'hot' pickups, such as humbuckers, try using the -6 dB input. If you want
an overdriven edge or "crunch," use the 0 dB input. In all cases, the Gain control setting will
establish the type of clean or overdriven sound being produced by the amp.
Note: Do not use both inputs at the same time!. The preamp is not designed for more than one
instrument to be played at a time.
3. Gain Control
The Traynor Small Block series Gain control allows you to set the level of the signal before
it's sent to the tone controls. This allows control of the tonal 'sensitivity' or 'definition' of the
amplifier. Higher Gain settings will give more 'growl' to your bass.
1
2
3
Input
Gain
Passive
Active
0
-6
Input
Gain
Passive
Active
0
-6
1
2
3
10
11
12
4
Bass
Low-Mid
Hi-Mid
Low-Mid
Hi-Mid
Bass
4
Status LED and Power Switch (switch located on rear)
1
0dB/Passive and -6dB/Active Inputs and Clip LED – ¼-inch phone jacks
2
Gain Control
3
Tone Controls – Bass, Low-Mid, Hi-Mid and Treble.
4
Low Expander Control
5
Master Volume Control (SB115 only)
6
Aux Input – ¼-inch phone jack
7
Phones Jack – ¼-inch TRS jack
8
GND Lift Switch (SB112 and SB115 only)
9
Line Out – XLR jack
Limiter Switch (SB115 only)
Tweeter Defeat/Active Switch (SB110 and SB112 only)
5
7
8
Low
Treble
Aux In
Phones
Expander
Low
Treble
MASTER
Expander
5
6
2
9
10
12
Line Out
Tweeter
IN
OUT
LIFT
GND
SB112
Aux In
Phones
Line Out
Limiter
Ground
IN
LIFT
OUT
GND
7
8
10
11
10
12
Line Out Tweeter
IN
OUT
SB110
Tweeter
IN
OUT
12
SB115
9
Publicité
