Install The Filter Lid - Jandy SFSM60 Manuel D'installation Et D'utilisation

Page 10
ENGLISH

3.4 inSTALL THe FiLTeR LiD

CAUTION
Ensure that the O-ring is completely clean and
lubricated with a non-petroleum based lubricant.
Before subjecting the filter to pressure, ensure that
the handle is revolved as tightly as possible so that a
good seal is achieved. See
WARNING
Follow these instructions carefully. Improper lid
installation can cause product failure or also cause
the filter lid to be blown off, which can result in death,
serious injury, or property damage.
3.4.1 ReMoVinG FiLTeR LiD
1. Turn the hand wheel (A) in an anti-clockwise direction until it
becomes loose. Fig. 7
2. Press down on the hand wheel firmly to release the O-ring.
Fig. 8
3. Before removing the lid, turn it 15º in an anti-clockwise
direction (B) Fig. 7. Lift the whole lid by the hand wheel.
A
Figure 7. Loosen Hand Wheel
3.4.2 RePLACinG FiLTeR LiD
1. Start with the lid completely off the filter to ensure the O-ring
is uncompressed. Fig 9
2. Insert the lid into the filter until it drops home. Turn the lid
15º in a clockwise direction (A), then turn the hand wheel (B)
as far as it will go in clockwise direction. Fig. 10
O-Ring
Figure 9. Ensure O-Ring is Uncompressed
Figure 5.
B
15°
Jandy Sand Filter SFSM
®
WARNING
Never attempt to adjust or remove the lid when the
pump is running or there is pressure in the system.
This can cause product failure or also cause the filter
lid to be blown off which can result in death, serious
personal injury, or property damage.
Inspect the lid and tank for any damage before
installing the lid. A damaged lid or tank could cause
the lid to be blown off which can result in death,
serious personal injury, or property damage.
Figure 8. Tap to Release O-Ring
A
Figure 10. Tighten Lid (A) Then Hand Wheel (B)
|
Installation & Operation Manual
B
15°