Operating - FALMEC Bellaria Mode D'emploi

operating

UK
and maintenance instructions
In the BELLARIA, the air passes through the dust ilter and ac-
tivated carbon ilter and then through the ioniser which acts
against the pollutants present in the home, ionising and puri-
fying the air that is fed back into the environment.
operation
Description
Key
Switches of and
reduces speed
Switching on and
increases
speed from 1 to 3
If pressed for 4 seconds, it activates
the automatic cycle:
BELLARIA will be activated only in the
presence of pollutants.
The function is disabled if:
• there are no pollutants detected for
3 hours.
• Keys and are pressed.
Light ON/OFF
When the light is ON, press the button to
reduce the light intensity.
air Quality
The air quality is displayed by the colour
of the 3 leaves.
Green = optimum quality.
Yellow = presence of pollutants.
The more pollutants present, the more intense the colour yellow.
wHicH Speed iS to Be Selected?
- 1st speed: keeps the air clean with low noise
(green leaves).
- 2nd speed: normal conditions of use.
(moderately yellow leaves).
- 3rd speed: high presence of pollutants
(yellow leaves).
ligHting
BELLARIA is equipped with high-eiciency, low-consumption LEDs, very
long life and "dimmer" function.
(see OPERATION)
maintenance
Regular maintenance guarantees proper operation and performance
over time.
Particular attention should be paid to the dust ilter and honeycomb car-
bon ilter: cleaning the ilters frequently reduces deposits of dust or other
particulate matter.
cleaning oF eXternal SurFaceS
Speed 1
It is recommended to clean the exterior surfaces of the BELLARIA peri-
odically: clean using a damp cloth slightly dampened with mild liquid
Speed 2
detergent or denatured alcohol. Finish of cleaning by rinsing well and
drying with soft cloths.
Speed 3
("+" LED lashing)
and
The glass can only be cleaned with speciic, non-corrosive or non-abra-
sive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with
these instructions.
lashing
cleaning oF internal SurFaceS
duSt FilterS
11
Bellaria
Before carrying out any cleaning or maintenance opera-
tions, disconnect from the power supply.
do not use detergents containing abrasive, acidic or cor-
rosive substances or abrasive cloths.
Do not use too much water next to the push button control
panel and lighting devices in order to prevent humidity from
reaching electronic parts.
It is forbidden to clean electrical parts, or parts related to the
motor or ioniser, with liquids or solvents.
For the internal metal parts, see the previous paragraph.
For this reason it is recommended to clean
the ilter frequently (at least every month)
using compressed air or by washing in a ba-
sin with warm water and a mild detergent.
Rinse it well and wait for it to be completely
dry before reassembling.