Publicité
Les langues disponibles
Les langues disponibles
Caution: Verify that the Power Cord (41) of the Sander/ Polisher is unplugged from its
extension cord or outlet prior to making any adjustments to the tool.
1.
Press in the Spindle Lock Cap (17) to keep the Spindle shaft from turning.
2.
Screw the Polishing Pad (2) counterclockwise onto the Spindle (3) until it is secure.
Release the Spindle Lock Cap (17).
Handle (19)
Spindle Lock Cap (17)
Polishing Pad (2)
Sanding Disk (47 or 48)
1.
Place a clean Foam Pad (44) securely onto the Polishing Pad (2).
NOTE: Prior to waxing or polishing a vehicle, make sure it's surface has been thoroughly
washed, and is free of dust, dirt, oil, grease, etc.
2.
Apply about two tablespoons of wax (not included) evenly on the Foam Pad (44).
Do not apply the wax directly to the surface of the vehicle. The amount of wax needed
will vary according to the size of the vehicle being waxed.
Carefully inspect the condition of the accessory before use and check the accessory
continually during use. If any damage is noted, stop immediately and replace the accessory
with an undamaged one. Harbor Freight Tools cannot be held responsible for damage
caused by using a damaged accessory on this tool.
NOTE: Avoid using too much wax. For additional applications of wax to the Foam Bonnet,
reduce the amount of wax. The Foam Bonnet will not absorb as much wax in subsequent
applications.
SKU 92623
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
Controls
Speed Adjustment (37)
Polishing
IMPORTANT
For technical questions, please call 1-800-444-3353
Lock-on Button
Switch (36)
Brush Holder
Cover (30)
Spindle (3)
Power Cord (41)
REV 06/05
English
Page 9
Publicité
