Sanitaire SC6010 Guide De L'utilisateur page 7

Machine à planchers commerciale
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FlrMachineOG_1618912.qxp_FloorMachine 3/22/19 1:59 PM Page 7
HOW TO OPER TE THE FLOOR M CHINE
1. First install the pad driver and pad, brush or
other attachments to be used.
2. Plug the machine in as directed and lower
the handle to the desired operating height
and lock in place using the cam lever
handle. (Does not apply to the SC6045
burnisher)
3. Push the safety switch forward and
squeeze the switch triggers beneath the
handle grips. This activates the motor and
starts the block, brush or attachment in
operation. Each time you release the
triggers the safety switch will reset. You will
need to follow the direction above to restart
the machine.
CAUTION: When leaving the machine
unattended, disconnect the wall plug and
return the handle to the "locked" upright
position to prevent accidental starting.
TO GUIDE YOUR FLOOR MACHINE
To move to the Right: Raise handle slightly.
The higher the handle is lifted, the faster the
machine will move to the right.
To move to the Left: To change direction,
lower the handle until the machine travels to
the left. The more the handle is lowered, the
faster the movement to the left. If you are not
experienced in the operation of this floor
machine, practice in an open area away from
any people, furniture or other obstacles.
DRIVE BELT ADJUSTMENT
SC6045 ONLY
See Fig. 1
1. Remove three (3) Phillips head screws
holding the pad center grip.
2. Remove four (4) large, slot head screws
holding drive pad.
3. Loosen pulley mount bolts with 9/16" deep
socket wrench. Do not remove the bolts.
4. Using a 1/2 box wrench, turn adjustment
nut until it touches the adjustment bolt
head. Turn the adjustment bolt to tighten or
loosen the belt tension.
5. Correct belt tension allows belt no more
than 1/4" of side movement.
6. Tighten the four (4) pulley mount bolts with
the 9/16" socket wrench.
7. Loosen the adjusting bolt until it is snug
against adjustment stop molded in housing
and turn adjustment nut against pulley
mount bracket.
8. Replace pad driver and pad center grip.
Motor bolt
Fig. 1
www.sanitairecommercial.com 7
Adjustment
nut

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sc6025Sc6030Sc6045

Table des Matières